Nanotechnological Product in matte finish with thermal and acoustic insulation performance. It works primarily breaking thermal bridges, who produces heat or cold losses, condensation and biocontamination´s problems. It produces an acoustic barrier who damps sounds waves. It dissipates them regardless of whether they come from inside or outside. Anti-mould preservative´s paint.
Application both exteriors and interiors. Thanks to its high adhesion can be applied directly on difficult surfaces, such as plastic, metal, PVC, etc. provided that a test is previously performed in a non-visible place. This will be useful to cover the drawers of the blinds and other elements that due to their poor insulation cause thermal bridges where the internal humidity condenses.
It is recommended painting interiors of plaster, "plasterboard", cement, plaster, etc. in order to improve thermal insulation and sound absorption, eliminating condensation problems.
Applied outdoors significantly reduces thermal bridges and improves the impermeability of the facade.
Modo de empleo:
On new surfaces, clean, dry and free of rust, grease or saltpeter of:
Cement and concrete: Wait for the complete setting before applying.
Plaster, plaster, plastic or wood: Fixing or sealing previously with appropriate products for each case.
Metal: Prepare the support and apply an antioxidant primer.
On old painted surfaces:
Paints in good condition: Wash and sand gently, putty if necessary.
Paints in poor condition: Remove and proceed as a new surface. If alkalinity is detected in the support, it must be corrected.
We will apply the undiluted Anti-Condensation Paint for brush or roller, and adjusting the viscosity with Jafep Water-based Paint and Enamel Diluent for spray or airless use.
Two to three coats of product will be applied, leaving more than 6 hours between each layer, until a minimum recommended thickness of 700 microns is reached. We must bear in mind that the thicker, the better the insulating properties of the material.
|Peso específico||0,90 ± 0,05 g/cm3|
|Viscosidad||21.000 ± 2.000 cp (in Brookfield)|
|Herramienta||Brush, Roller, Gun or Airless|
|Espesor mínimo||700 micras|
|Rendimiento||2 - 4 m2/L/coat|
|Diluyente||Diluent for water-based paints and enamels|
|Repintado||6 - 8 hours|